Quietside QSCC-183 Installation Manual download pdf (Page 10)

E-10

INSTALLING THE AIR CONDTIONER

Installing and Connecting the Drain Hose of the Indoor Unit

When installing the drain hose for the indoor unit, check if condensation draining is adequate.

When passing the drain hose through the 65-mm hole drilled in the wall, check the following:

Drain hose installation:

If necessary, connect the 6.6 ft (2m) extension drain hose to the drain hose.

If you use the extension drain hose, insulate the inside of the extension drain

hose with a shield.

Fit the drain hose into 1 of 2 drain hose holes, then fix the end of the drain

hose tightly with a clamp.



If you don’t use the other drain hose hole, block it with a rubber stopper.

Pass the drain hose under the refrigerant pipe, keeping the drain hose tight.

Pass the drain hose through the hole in the wall. Check if it slants downwards

as seen in the picture.

 The hose will be fixed permanently into position after finishing

the installation and the gas leak test; refer to page 14 for further details.

Shield

Drain hose Extension drain hose

The hose must

NOT slant upwards.

The end of the drain

hose must NOT be

placed under water.

Do NOT bend the hose

in different directions.

Keep a clearance of

at least 2inch (50mm)

between the end of the

hose and the ground.

Do NOT place the end

of the drain hose in a

hollow.

2inch

(50mm)

less

Ditch

Vivace1,2_KCV_Inv_DB98-27560A_IM_E.indd 10 2007-3-13 18:51:41

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16 17 18

No comments

Quietside QSCC-183 Installation Manual Page 10